Wave Bar is a pry bar I am making from Ti-6Al-4V (grade 5 titanium) on the Tormach PCNC 770 under the Malham Machine Co. name. This is bar 1, the first article, and it did not all go to plan.
The finished bar is 5.000 x 1.015 x 0.250 in, with a wedge at one end, a butt at the other, a choil on the front edge, a lanyard slot near the butt, and a 0.008-deep wave-field engraving on side A.
What happened on bar 1
- Faced both sides to 0.250 in the vise (measured 0.247 to 0.250). The face mill was set up in CAM without its insert radius and left a lip, fixed with a skim pass.
- OP30 ran on an aluminum sub-plate with two 0.374 locating bosses: the bevel, then the wave field (0.020 tapered ball engraver, 20 degrees per side, 10,000 rpm), then the profile, leaving a 0.007 onion skin and a 0.020 top chamfer.
- The lanyard slot went wrong. A 1/8 in end mill glowed red and welded titanium to itself, and a second one burned too. Titanium punishes rubbing: a tiny chip load, a narrow slot and trapped chips all add up to heat.
Changes for bar 2
The slot is widened from 0.130 to 0.160 and cut as a helical racetrack instead of a plunge, with 3-flute Ti-rated AlTiN tools and pre-drilled slot ends. I also removed the profile air-cutting in Fusion, which saves about 20 minutes per bar, and added a full-outline chamfer program.
Next comes the OP40 flip for the maker’s mark and release chamfer, then bead blast, stonewash and anodize. Bar 2 is up next.